 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| PRELIMINARY INFORMATION I C R O C LOC K Description The MK3723 is ICS/MicroClock's lowest cost, low jitter, high performance 3.3 volt VCXO designed to replace expensive VCXO modules. The on-chip Voltage Controlled Crystal Oscillator accepts a 0 to 3.3 V input voltage to cause the output clocks to vary by 100 ppm. Using ICS/MicroClock's patented VCXO techniques, the device uses an inexpensive external pullable crystal in the range of 16 - 28 MHz to produce a VCXO output clock that is a divide by 2, 4, 6, or 8 or the crystal frequency. ICS/MicroClock manufactures the largest variety of Set-Top Box and multimedia clock synthesizers for all applications. If more clock outputs are needed, see the MK3732 or MK377x family of parts. Consult ICS/MicroClock to eliminate VCXOs, crystals and oscillators from your board. MK3723 Low Cost 3.3 Volt VCXO Features * Packaged in 8 pin SOIC * 3.3 V only operating voltage * 2 MHz to 14 MHz VCXO operation * Ideal for 26 MHz from a 28 MHz crystal * Uses an inexpensive external crystal * On-chip VCXO (patented) with pull range of 200 ppm (minimum) * VCXO tuning voltage of 0 to 3.3 V * 12 mA output drive capability at TTL levels * Advanced, low power, sub-micron CMOS process * For frequencies between 16.2 MHz and 28 MHz use the MK3721S. For higher than 28 MHz, use the MK3732-05 Block Diagram VIN X1 16 -28 MHz pullable crystal X2 Voltage Controlled Crystal Oscillator /N Output Buffer VCXOCLK S1, S0 MDS 3723 A 1 Revision 082800 Integrated Circuit Systems, Inc. * 525 Race Street * San Jose *CA * 95126* (408)295-9800tel * www.icst.com PRELIMINARY INFORMATION I C R O C LOC K Pin Assignment MK3723 X1 VDD VIN GND 1 2 3 4 8 7 6 5 X2 S1 VCXOCLK S0 MK3723 Low Cost 3.3 Volt VCXO Divider Select Table S1 0 0 1 1 S0 0 1 0 1 VCXOCLK (MHz) Crystal /2 Crystal /4 Crystal /6 Crystal /8 0 = connect directly to ground 1 = connect directly to VDD 8 pin (150 mil) SOIC Pin Descriptions Number Name Description 1 X1 Crystal connection. Connect to a pullable 10 to 20 MHz crystal. 2 VDD VDD. Connect to + 3.3 V. 3 VIN Voltage input to VCXO. Zero to 3.3 V analog input which controls the frequency of the VCXO. 4 GND Connect to ground. 5 S0 Select pin for VCXO divider. See table above. 6 VCXOCLK VCXO clock output. Full CMOS output amplitude. 7 S1 Select pin for VCXO divider. See table above. 8 X2 Crystal connection. Connect to a pullable 16 to 28 MHz crystal. Crystal Specifications Correlation (load) capacitance Initial accuracy Drift over temperature and aging C0/C1 ratio ESR 14 pF 20 ppm maximum 50 ppm maximum 240 maximum 35 maximum MDS 3723 A 2 Revision 082800 Integrated Circuit Systems, Inc. * 525 Race Street * San Jose *CA * 95126* (408)295-9800tel * www.icst.com PRELIMINARY INFORMATION I C R O C LOC K Electrical Specifications Parameter Supply voltage, VDD Inputs and Clock Outputs Ambient Operating Temperature Soldering Temperature Storage temperature Operating Voltage, VDD Output High Voltage, VOH Output Low Voltage, VOL Output High Voltage, VOH, CMOS level Operating Supply Current, IDD Short Circuit Current VIN, VCXO control voltage Input Crystal Frequency Input Crystal Accuracy VCXO Output Clock Frequency Output Clock Rise Time Output Clock Fall Time Output Clock Duty Cycle Maximum Absolute Jitter, short term Output frequency pullability, note 2 Notes: Conditions Referenced to GND Referenced to GND Max of 10 seconds MK3723 Low Cost 3.3 Volt VCXO Minimum Typical Maximum 7 VDD+0.5 70 260 150 3.45 0.4 Units V V C C C V V V V mA mA V MHz ppm MHz ns ns % ps ppm ABSOLUTE MAXIMUM RATINGS (note 1) -0.5 0 -65 3.15 2.4 VDD-0.4 4 50 0 16 2 0.8 to 2.0V 2.0 to 0.8V At VDD/2 0V VIN 3.3 V 3.3 28 30 14 1.5 1.5 60 DC CHARACTERISTICS (VDD = 3.3 V unless noted) IOH=-12mA IOL=12mA IOH=-4mA No Load AC CHARACTERISTICS (VDD = 3.3 V unless noted) 40 100 50 100 180 1. Stresses beyond those listed under Absolute Maximum Ratings could cause permanent damage to the device. Prolonged exposure to levels above the operating limits but below the Absolute Maximums may affect device reliability. 2. With a ICS/MicroClock approved pullable crystal. External Components The MK3723 requires a minimum number of external components for proper operation. A decoupling capacitor of 0.01F should be connected between VDD and GND on pins 2 and 4, as close to the MK3723 as possible. A series termination resistor of 33 may be used for the clock output. The input crystal must be connected as close to the chip as possible. The input crystal should be a parallel mode, pullable, AT cut, with 14 pF load capacitance. See previous page for crystal specifications. Consult ICS for recommended suppliers. IMPORTANT - read application note MAN05 before laying out the PCB. MDS 3723 A 3 Revision 082800 Integrated Circuit Systems, Inc. * 525 Race Street * San Jose *CA * 95126* (408)295-9800tel * www.icst.com PRELIMINARY INFORMATION I C R O C LOC K MK3723 Low Cost 3.3 Volt VCXO Package Outline and Package Dimensions (For current dimensional specifications, see JEDEC Publication No. 95.) 8 pin SOIC Symbol A A1 B C D E e H h L Inches Min Max 0.0532 0.0688 0.0040 0.0098 0.0130 0.0200 0.0075 0.0098 0.1890 0.1968 0.1497 0.1574 .050 BSC 0.2284 0.2440 0.0099 0.0195 0.0160 0.0500 Millimeters Min Max 1.35 1.75 0.10 0.24 0.33 0.51 0.19 0.24 4.80 5.00 3.80 4.00 1.27 BSC 5.80 6.20 0.25 0.50 0.41 1.27 E H INDEX AREA D A1 e B A C L Ordering Information Part/Order Number MK3723S MK3723STR Marking MK3723S MK3723S Shipping packaging tubes tape and reel Package 8 pin SOIC 8 pin SOIC Temperature 0-70 C 0-70 C While the information presented herein has been checked for both accuracy and reliability, Integrated Circuit Systems Incorporated (ICS) assumes no responsibility for either its use or for the infringement of any patents or other rights of third parties, which would result from its use. No other circuits, patents, or licenses are implied. This product is intended for use in normal commercial applications. Any other applications such as those requiring extended temperature range, high reliability, or other extraordinary environmental requirements are not recommended without additional processing by ICS. ICS reserves the right to change any circuitry or specifications without notice. ICS does not authorize or warrant any ICS product for use in life support devices or critical medical instruments. MDS 3723 A 4 Revision 082800 Integrated Circuit Systems, Inc. * 525 Race Street * San Jose *CA * 95126* (408)295-9800tel * www.icst.com |
Price & Availability of MK3723STR
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |